AMCCF Forum | |
Merkkikeskustelua (AMC/Rambler/Nash/Hudson/Jeep) >> Kori, Jarrut, Sisusta, Renkaat, Vanteet, Sähkölaitteet, jne. >> Cherokee XJ huono tyhjäkäynti + pätkiminen
https://amccf.com/cgi-bin/yabb2/YaBB.pl?num=1257615971 Aiheen aloittaja A-V 07.11.09 klo 19:46:10 |
Aihe: Re: Cherokee XJ huono tyhjäkäynti + pätkiminen Kirjoittaja petpi 30.04.12 klo 16:56:08 aki järvelin kirjoitti 30.04.12 klo 15:57:58:
THROTTLE POSITION SENSOR TEST To perform a complete test of this sensor and its circuitry, refer to the DRB scan tool. Also refer to the appropriate Powertrain Diagnostics Procedures manual. To test the sensor only, refer to the following: The throttle position sensor can be tested with a digital voltmeter. The center terminal of the sensor connector is the output terminal. With the ignition key in the ON position and engine not running, check the sensor output voltage at the center terminal wire of the connector. Check this at idle (throttle plate closed) and at wide open throttle (WOT). At idle, sensor output voltage should be greater than 200 millivolts. At wide open throttle, sensor output voltage must be less than 4.8 volts. The output voltage should increase gradually as the throttle plate is slowly opened from idle to WOT. |
AMCCF Forum » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. Kaikki oikeudet pidätetään. |